Chapter 3 Software Application And Usage; Introduction; Configuring Ip/Mac Addresses And Other Network Settings - Supermicro AOC-SIM1U-3B User Manual

Software Application and Usage
3-1

Introduction

With an independent I/O processor embedded in Raritan's Kira 100 RISC System Chip,
the AOC-SIM1U-3B/3B+ add-on card allows you to access, monitor, manage and
interface with systems that are in remote locations via LAN. The necessary utilities for
the access and configuration of the add-on card are included on the Supermicro
bootable CDs that came with your card. This section provides information on the
configuration and the access of the IPMI card on the network.
NOTE: KVM-over-LAN is available on the AOC-SIM1U-3B+ only. All features
and options related to the functionality of KVM-over-LAN are supported by the
AOC-SIM1U-3B+ only.
3-2 Configuring IP/MAC Addresses and other Network
Settings
To configure IP/MAC addresses and other IPMI network settings using the IPMICFG
utility, use the procedure below.
Configuring an IP/MAC Address or Other IPMI
1. Run the IPMICFG utility from the bootable CD that came with your shipment.
2. Refer to the table below to configure the IP/MAC addresses.
Board IPMI
X7 Series with LAN
SIM1U-3B(+)
82563EB, 82575
H8 DDR2 Memory SIM1U-3B(+)
3. Follow the instructions given in the Readme.txt file to configure Gateway IP/
Netmask IP addresses, to enable/disable DHCP and to configure other IPMI
settings.
Chapter 3
MAC IP
IPMI Card Available IP/DHCP
IPMI Card Available IP/DHCP
3-11
Communication
Through
Dedicated LAN
LAN1 on Mainboard
Dedicated LAN
LAN1 on Mainboard