Supermicro AOC-SIM1U-3B User Manual page 50

AOC-SIM1U-3B/3B+ Add-on Card User's Manual
Table 3-18. Network Screen Controls
Item Name
Network Basic
1
Settings
2 IP Auto Configuration
3 Preferred Host Name
4 IP Address
5 Subnet Mask
6 Gateway IP Address
Primary DNS Server
7
IP Address
Secondary DNS
8
Server IP Address
Network
9
Miscellaneous Setting
Remote Console &
10
HTTPS Port
11 HTTP Port
12 SSH Port
13 Bandwidth Limit
14 Enable SSH Access
Disable Setup
15
Protocol
16 LAN Interface Setting This section allows you to configure LAN Interface settings.
17 LAN Interface Speed
LAN Interface Duplex
18
Mode
Description
This section allows you to configure basic settings for your network.
Select a desired item from this drop-down list for your IP Auto
Configuration. The options are N
Enter a Preferred Host Name in the field provided.
NOTE: This field is used for DHCP settings only.
Enter the IP Address for the remote host in the field provided.
Enter the net mask of the local network in the field provided.
Enter the local network router's IP address in this field for the
accessibility of the users that are not connected to the local network.
Enter the IP Address of the Primary Domain Name Server in this
field.
Enter the IP Address of the Secondary Domain Name Server in the
field. It will be used when the Primary DNS Server cannot be
contacted.
This section allows you to configure Network Miscellaneous settings.
Enter the port numbers that the remote host and the HTTP server
are listening. If a number is not entered in the field, the default value
is used.
Enter the port number that the HTTP server is listening. If a number
is not entered in the field, the default value is used.
Enter the port number the SSH server is listening. If a number is not
entered in the box, the default value is used.
Enter the maximum bandwidth value for network interfacing. The
value should be in Kbits per second.
Click this check box to enable SSH Access.
Check this check box to disable the Setup Protocol function for the
SIMBL card.
Use this drop-down list box to select a desired speed. The options
are: A - , 10 M
UTO DETECT EGA BITS PER SECOND
. If A - is selected, the LAN Interface Speed will be
SECOND UTO DETECT
set at the optimized speed based on the system configurations
detected by the OS.
Use this drop-down list box to select a desired LAN Interface Duplex
Mode. The options are: A -
UTO DETECT
D . If A - is selected, the LAN Interface Duplex Mode
UPLEX UTO DETECT
will be set to the optimized setting based on the system
configurations detected by the OS.
3-42
, DHCP, and BOODP.
ONE
or 100 M
EGA BITS PER
, H D and F
ALF UPLEX ULL