Supermicro AOC-SIM1U-3B User Manual page 61

Table 3-23. Event Log Screen Controls
Item Name
1 Event Log Targets
2 List Logging Enabled
Entries Shown Per
3
Page
4 Clear Button
5 NFS Logging Enable
6 NFS Server
7 NFS Share
8 NFS Log File
SMTP Logging
9
Enable
10 SMTP Server
Receiver Email
11
Address
Sender Email
12
Address
SNMP Logging
13
Enable
14 Destination IP
15 Community
Event Log
16
Assignments
17 Apply Button
Reset to Defaults
18
Button
Chapter 3: Software Application and Usage
Description
This section allows you to manually set event log targets and
settings.
Checking this box activates the event-logging list. To show the event
log list, click on the E L menu option from the M
VENT OG
menu.
NOTE: The maximum number of log list entries is 1,000 events.
Every entry that exceeds this limit automatically overrides the oldest
one in the list. If the R button is pressed, all logging information
ESET
is saved; however, all logging data is also lost if a hard reset is
performed or the system loses power.
Enter the number of entries you want to display on a page into this
field.
Click this button to clear the internal event log from the memory.
Checking this box enables NFS Logging, which creates a Network
File System (NFS) for the event logging data.
Enter the IP Address of the NFS Server into this field.
Enter the path of the Network File System in which the event logging
data is stored into this field.
Enter the filename of the Network File System in which the event
logging data is stored into this field.
Checking this box enables SMTP (Simple Mail Transfer Protocol)
logging.
Enter the IP Address for the SMTP Server into this field.
Enter the email address into this field that the SMTP event logging
data is sent.
Enter the email address from which the SMTP event logging data is
sent into this field.
Checking this box enables SNMP (Simple Network Management
Protocol) logging.
Enter the IP address where the SNMP trap is sent into this field.
Enter in this field the name of the community if the receiver requires
a community string.
This section allows you to specify the types and the destination for
event logging. For each event listed in this section, check the box
next to it if you want to list it for your event log.
Click on this button to apply your selections from this screen to the
system.
You can cancel your selections and switch back to the default values
by clicking on this button.
3-53
AINTENANCE