Page 1
PEGASUS 56 ISTRUZIONE PER L’USO L'INSTALLAZIONE E LA MANUTENZIONE INSTRUCCIONES DE USO, INSTALACIÓN Y MANTENIMIENTO KULLANMA, KURULUM VE BAK M TALIMATLAR INSTRUCTIONS FOR USE, INSTALLATION AND MAINTENANCE INSTRUCTIONS D'UTILISATION, D'INSTALLATION ET D'ENTRETIEN...
2.6 Faults PEGASUS 56 is a high-efficiency heat generator for central heating using natural gas or liquefied Given below are the faults that can be caused by simple, user-solvable problems. gas (configurable at the time of installation) and regulated by an advanced electronic control sys- tem.
PEGASUS 56 3. INSTALLATION Water system characteristics In the presence of water harder than 25° Fr, it is advisable to use suitably treated water, 3.1 General Instructions in order to avoid possible scaling in the boiler caused by hard water, or corrosion pro- This unit must only be used for its intended purpose.
4 - Pressure adjustment Safety devices Gas valve Decrease pressure The boiler PEGASUS 56 is equipped with devices that guarantee safety in case of oper- Increase pressure ation faults. Ignition step adjustment for G20-G25 NATURAL gas Automatic reset temperature limiter (safety thermostat) Ignition step adjustment for G30-G31 LIQUEFIEDgas This device prevents the water temperature in the system from exceeding boiling point.
Page 5
PEGASUS 56 Opening the front casing Combustion analysis To open the front casing, see the sequence in fig. 5. A fume sampling point has been included in the upper part of the anti-backflow device inside the boiler (see fig. 7).
PEGASUS 56 Pilot burner assembly 4.4 Troubleshooting Table. 1 - Fault list Fault Cause Cure Pilot burner nozzle dirty Clean the nozzle with compressed air Air in gas pipes Check the regular gas flow to the boiler and that the air has been eliminated...
Dichiarazione di conformità Il costruttore: FERROLI S.p.A. Indirizzo: Via Ritonda 78/a 37047 San Bonifacio VR dichiara che questo apparecchio è conforme alle seguenti direttive CEE: • Direttiva Apparecchi a Gas 90/396 • Direttiva Rendimenti 92/42 • Direttiva Bassa Tensione 73/23 (modificata dalla 93/68) •...
Déclaration de conformité Le constructeur : FERROLI S.p.A. Adresse: Via Ritonda 78/a 37047 San Bonifacio VR déclare que cet appareil est conforme aux directives CEE ci-dessous: • Directives appareils à gaz 90/396 • Directive rendements 92/42 • Directive basse tension 73/23 (modifiée 93/68) •...