Interquartz Voyager 9281 User Manual

Voyager Memory Phone 9281

General

This INTERQUARTZ telephone is intended for use on 2 wire analogue PSTN and PABX circuits within Europe.

Declaration of Conformity

Interquartz (UK) Limited declares under its sole responsibility that this product
Model : VOYAGER MEMORY PHONE 9281
Is in conformity with the following relevant harmonized standards
Health & Safety
Electromagnetic Compatibility
Telecom
Following the provisions of Council Directive on radio equipment and telecommunications terminal equipment

Notes

1. The REN number of this telephone is 1.
2. The European code for emergency services is 112. You can still use 999 in the UK. An access code may be
required if the phone is connected to a PABX

Installation

1. Plug in the line cord to the line socket at the rear of the telephone
(Figure 3)
2. Plug in the handset cord to the handset socket at the side of
the telephone.
3. Set the ringer volume control, and ringer pitch adjust as desired
(Figure 3)
4. If the telephone is for wall mounting then you need to re-position
the handset retainer as shown in (Figure 1) before mounting
in the telephone on the wall.
4.1 Use screw-driver to push the handset retainer
4.2 Push the handset retainer out of the slot
4.3 Turn the handset retainer 180 degree
4.4 Insert the handset retainer back into it's slot
5. Do not adjust the switches located at bottom case. Contact your PABX Manager or Network Supplier if you
need to adjust the Recall switch (TBR/ER) and Voice Message (S1/ S2 / N) switch
EN60950 : 1992
EN55022 : 1998 & EN55024 : 1998
EN301437 : 1999 & TBR38 : 1998
January 2002
FIGURE 1