Using The Headset; Using The Intercom - Cardo Systems SCALA RIDER TEAMSET PRO User Manual

USING THE HEADSET

GENERAL USAGE
GENERAL FUNCTIONS
DESIRED RESULT: REQUIRED ACTION:
Turn on the
Press the CTRL Button steadily for at least three
headset seconds
Turn off the Press the CTRL Button steadily for at least three
headset
seconds
Increase the Tap the Volume Up Button
volume
Decrease the Tap the Volume Down Button
volume
AGC (Automatic Gain Control): In addition to manual Volume Control,
the scala rider TeamSet
its volume according to ambient noise and driving speed.
AUDIO SOURCES AND PRIORITIES
The different Audio Sources that are connected to the scala rider
TeamSet are prioritized as follows:
pro
Highest 1. Mobile phone Audio / GPS device (Incoming/outgoing calls ,
GPS audio and navigation instructions)
2. Intercom Buddy Audio
Lowest 3. MP3 Connectivity
A high priority Audio Source will always interrupt any lower priority
Audio Source.
i.e. Mobile phone call interrupts Intercom call
Intercom call interrupts MP3 connectivity
8 scala rider ® TeamSet ™
PRO
will automatically increase and reduce
pro

USING THE INTERCOM

Making Intercom calls
To start an Intercom call with your Buddy while the headset is
on Standby you can either:
VOICE CONNECT:
Start talking
A Buddy Intercom call will be
established and stay on until
both sides are quiet for 30
seconds.
NOTE: While the Intercom is on, the Redial and Voice Dial functions will be
disabled.
Busy Status: On the scala rider TeamSet
a Buddy Intercom call with a Buddy that is already on a Phone/GPS/In-
tercom call, you will hear a double beep indicating the Buddy is busy.
Reconnecting the Intercom: If the scala rider TeamSet
its Intercom Buddy headset go out of range and disconnect from
each other, the scala rider TeamSet
reconnect to its Intercom Buddy for five minutes.
You can manually reconnect at any time by tapping the Intercom
Button.
Receiving Intercom calls
If you are not speaking with any one, once the other party tries to
initiate a Buddy Intercom call, the call will begin immediately.
INTERCOM BUTTON
CONNECT:
or
Single tap the Intercom
Button
A Buddy Intercom call will be
established. To end the Buddy
Intercom call, single tap the
Intercom Button again.
, if you attempt to start
pro
and
pro
will automatically try to
pro