Reader Parameters; Scan Parameters - Datalogic Skorpio User Manual

USE AND FUNCTIONING
3

Reader Parameters

The barcode reading parameters and values are dependent upon the type of scanner
module mounted in your mobile computer. For a detailed list of parameters and of
their configuration procedures, please refer to the SDK Help file on the CD.

Scan Parameters

The Scan Parameters are common to all scanner modules and allow control of the
scanning device. The Scan parameters are described as follows:
ScanTimeout: the maximum time, in milliseconds, during which the scanner remains
on without decoding any barcode.
GoodReadSound: is the filename of a wav file played when the scanner reads a
code.
LedDuration: the length of the good-read led pulse, in milliseconds.
LedPulses: the number of times the good-read led pulse is emitted when the
scanner reads a code.
Green Spot Duration: determines the duration (measured in milliseconds) of the
green spot feedback, which provides a "good read" green dot directly on the code,
where the operator usually tends to be looking.
ContinuousMode: disables the effect of the ScanTimeout parameter.
KeyboardEmulation: if enabled all scanned data are transformed into keyboard
events and can therefore be displayed and saved to a file as if input from the mobile
computer keyboard.
SoftTrigger: when enabled, the laser can be turned on/off by the application
software.
ScanAlwaysOn: enables the scanner for barcode reading independently from the
application software.
NotPrintableChar: if set to "Remove", all not printable characters included in the
scanned data are deleted and the final barcode will include only printable characters.
23