Table of Contents
Advertisement
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information,
a
complete
User's Manual
can be found in the
Bonus Pack CD
Disc. Thanks for
the help of saving our earth!
This Easy Installation Guide x 1
80-Wire IDE Cable x 1
Floppy Drive Cable x 1
Bonus Pack CD x 1
Motherboard x 1
PART NO: 49.88H01.002
DOC. NO: MX34U-EG-E0112B
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
Online
5. Connect ATX power cable back to connector PWR2.
This motherboard has AC'97 sound onboard. JP12 is used to enable or disable onboard AC97 CODEC chip.
If you don't want to enable the Onboard Audio, you should set this jumper to 2-3, and disable the "OnChip
Sound" from BIOS setting > Advanced Chipset Features, before you install your preferred PCI Sound Card.
1. JP14 Clear CMOS
1
1
Normal
Clear CMOS
(default)
2. JP12 Enable/Disable Onboard Audio
Pin 1
JP12 Onboard Audio jumper
1
1
Enable
Disable
(Default)
Tip: When should I Clear CMOS?
1. Boot fail because of overclocking...
2. Forget password...
3. Troubleshooting...
Advertisement
Table of Contents
