Refrigerating Cycle - LG TWC051HGAA2.AWYBLAT (W051CA) Service Manual

10. CAPACITOR
1. Remove the cabinet. (Refer to Section 2)
2. Remove the control board. (Refer to Section 3)
3. Discharge the capacitor by placing a 20 K resistor
across the capacitor terminals.
4. Remove the screw which fastens the capacitor clamp.
5. Remove all the leads of capacitor terminals.
6. Re-install the components by referring to the removal
procedure above. (See Figure 26)
11. THERMOSTAT
1. Remove the cabinet. (Refer to Section 2)
2. Remove the control board. (Refer to Section 3)
3. Remove 2 screws which fasten the thermostat.
(See Figure 27)
4. Remove all the leads of the thermostat terminals.
5. Remove the thermostat.
6. Re-install the components by referring to the removal
procedure above.
12. ROTARY SWITCH
1. Remove the cabinet. (Refer to Section 2)
2. Remove the control board. (Refer to Section 3)
3. Remove 2 screws which fasten the rotary switch.
(See Figure 28)
4. Remove all the leads of the rotary switch terminals.
5. Remove the rotary switch.
6. Re-install the components by referring to the removal
procedure above.
13. POWER CORD
1. Disconnect the unit from source of power.
2. Remove the front grille. (Refer to Section 1)
3. Remove the cabinet. (Refer to Section .2)
4. Remove a screw that secures control board to base pan
and air guide. (Refer to Section 3)
5. Pulls the control board toward you.
6. Disconnect the 2 receptacles and remove the grounding
screw.
7. Remove a screw securing the clip with cord to the con-
trol board. (See Figure 29)
8. Pull the power cord.
9. Re-install by referring to procedures above.

Refrigerating Cycle

14. CONDENSER
1. Remove the cabinet. (Refer to Section 2)
2. Discharge the refrigerant by using a refrigerant recovery
system.
3. Remove 2 screws which fasten the condenser.
(See Figure 30)
4. After discharging the refrigerant completely, unbraze the
interconnecting tube at the condenser connections.
5. Remove the condenser.
6. Re-install by referring to the procedures above.
12 Room Air Conditioner
Disassembly
Figure 26
Figure 27
Figure 28
Figure 29
Figure 30