Air Handling Parts - LG TWC051HGAA2.AWYBLAT (W051CA) Service Manual

Air Handling Parts

4. AIR GUIDE UPPER
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 1)
3. Remove the cabinet. (Refer to Section 2)
4. Remove the control board. (Refer to Section 3)
5. Remove 2 screws that secure the brace to air
guide upper and shroud. (See Figure 18)
6. Remove 2 screws that secure the air guide
upper to air guide lower. (See Figure 8)
7. Lift air guide upper upward.
8. Re-install by referring to the procedures above.
5. ORIFICE, TURBO FAN AND FAN
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section )
3. Remove the cabinet. (Refer to Section 2)
4. Remove the control board. (Refer to Section 3)
5. Remove the air guide upper. (Refer to Section 24)
6. Remove 2 screws that secure the base pan to con-
denser. (See Figure 19)
7. Remove 2 screws that secures the shroud to
channel of condenser.
8. Press the snap area of shroud with your thumbs.
This allows you to remove it from the condenser.
9. Lift the compressor upward with the evaporator and
condenser. (See Figure 19)
10. Remove the orifice by pushing the snap area of the air
guide blower. (See Figure 20)
11. Remove the clamp springs which are clamped to the
boss of fan and turbo fan by hand plier.
(See Figure 21)
12. Pull the fan and turbo fan outward.
13. Remove the shroud.
14. Re-install by referring to the procedures above.
10 Room Air Conditioner
Figure 18
Figure 19
Figure 20
Figure 21
Disassembly