Refrigerating Cycle - LG LW5012 Service Manual

Disassembly
10. CAPACITOR
1. Remove the cabinet. (Refer to Section 2)
2. Remove the control panel. (Refer to Section 3)
3. Discharge the capacitor by placing a 20 KΩ resistor
across the capacitor terminals.
4. Remove all the leads of capacitor terminals.
5. Re-install the components by referring to the removal
procedure above. (See Figure 26)
11. THERMOSTAT
1. Remove the cabinet. (Refer to Section 2)
2. Remove the control panel. (Refer to Section 3)
3. Remove 2 screws which fasten the thermostat.
(See Figure 27)
4. Remove all the leads of the thermostat terminals.
5. Remove the thermostat.
6. Re-install the components by referring to the removal
procedure above.
12. ROCKER SWITCH
1. Remove the cabinet. (Refer to Section 2)
2. Remove the control board. (Refer to Section 3)
3. Remove all the leads of the rotary switch terminals.
4. Remove the rocker switch.(See Figure 28)
5. Re-install the components by referring to the removal
procedure above.
13. POWER CORD
1. Disconnect the unit from source of power.
2. Remove the front grille. (Refer to Section 1)
3. Remove the cabinet. (Refer to Section .2)
4. Remove a screw that secures control panel to control
box. (Refer to Section 3)
5. Pull the power cord. (See Figure 29)
6. Re-install by referring to procedures above.

Refrigerating Cycle

14. CONDENSER
1. Remove the cabinet. (Refer to Section 2)
2. Discharge the refrigerant by using a refrigerant recovery
system.
3. Remove 2 screws which fasten the condenser.
(See Figure 30)
4. After discharging the refrigerant completely, unbraze the
interconnecting tube at the condenser connections.
5. Remove the condenser.
6. Re-install by referring to the procedures above.
16 Room Air Conditioner
Figure 26
Figure 27
Figure 28
Figure 29
Figure 30