Dc Ignition Unit Mounting - Zenoah G200PU Owner's Manual

DC IGNITION UNIT MOUNTING

1. Make sure to install the power switch.
2. Push the sparkplug cap all the way over the sparkplug.
3. Fixate the body within the fuselage, as shown in the diagram. Make sure
that the sponge, cloth or the like is not enclosed.
4. The temperature of the bottom surface (D) of the unit, in particular, will
rise. Thus, when fixating surface (D), make sure to leave sufficient space
(a gap).
The temperature of the unit may rise to as high as 70~80°C,
depending on the operating environment and conditions, but
this is not abnormal. However, make sure not to touch this
part or you could risk being burned.
Bolt (4mm)
Ground
wire
Sensor wire
Unit
Battery wire
surface D
Sparkplug wire
Switch
Capacity: 3A (or higher)
For charging
Nic battery 4.8V
1500~2700mA
Use of anything
other than an 4.8V
battery is prohib-
ited.
surface D
Gap: 5mm or more
surface D
surface
D
surface
D
surface D
Sponge & cloth
7