Set Up - Zenoah BK3402FL Owner's Manual

BK3402FL / BK3402FL-EZ / BK3402FLJ / BK3402FLJ-EZ / BK4302FL / BK4302FL-EZ / BK4302FLJ / BK4302FLJ-EZ

6. Set up

WARNING
• Assemble each part correctly. Wrong assembly
might cause an accident.
• If you cannot do the assembling yourself, consult
the shop where you bought this product.
■ ATTACHING THE SHOULDER STRAP
1. Pass the ring of the shoulder strap through the
hook(A) and fix it by the bolt securely.
2. Set the hook(B) of each shoulder strap to the D-rings
on the frame.
■ CONNECTING THE THROTTLE WIRES
1. Run the throttle wire of the engine through the protec-
tive tube and the right-hand grip as shown in fig-
ure.
2. Hook the throttle-wire-end into the hole of the throttle
lever, pull the throttle wire, and fit its cap to the wire
receiver.
(2)
(1)
(1) Throttle wire
(2) Protective tube
(3) Throttle wire cap
(4) Throttle wire end
01-BK3402･4302_GB_208＿三.indd 9
■ JOINTING THE FLEXIBLE SHAFT TO THE
1. Remove the screw of the joint and insert the liner into
2. Then tighten the screw on the joint until the tip of the
(A) UPPER SIDE
(B) LOWER SIDE
(1) Hook (A)
(2) Bolt
(3) D-ring
(4) Hook (B)
Check and make sure the throttle-wire-cap is securely
seated in the wire receiver of the throttle lever after
connecting the throttle wire to the throttle lever.
After connecting the liner into the joint, pull the liner to
make sure it will not come out from the joint.
■ CONNECTING THE FLEXIBLE SHAFT TO
Turn the hole at the end of the flexible shaft upward,
align the square hole of the clutch drum with the direc-
tion of the inner shaft, and thrust the flexible shaft into
the clutch housing until you hear a click.
(4)
(3)
After connecting the flexible shaft to the clutch housing,
try to pull out the flexible shaft by hand to make sure
the flexible shaft does not come off.
MAIN PIPE
the joint.
screw reaches a groove of the liner.
Note that the tip of the screw must not touch the
stopper in the groove.
(1)
(2)
(4)
(5)
WARNING
IMPORTANT
THE ENGINE
IMPORTANT
G
B
(1) Screw
(3)
(2) Groove
(3) Joint
(4) Stopper
(5) Liner
(1) Clutch housing
(2) Clutch drum
square-hole
(3) Hole
GB-9
12.9.14 11:08:22 AM