Set Up - Zenoah BC4301FW Owner's Manual

5. Set up

■ ENGINE and MAIN PIPE
Align the hanger and the fuel tank, using attached 4
socket screws, secure the connection firmly with equal
force. (F1)
F1
■ HANDLE
1. Loosen the 4 bolts on the handle bracket. (F2)
2. Insert the right handle (throttle lever is attached) and
the left handle assembly into the bracket and
retighten the bolts securely. (F2)
F2
■ SAFETY GUARD
Attach the safety guard to the gear case and fix it with
the clump and 2 bolts ( M6x30) securely. (F3)
F3
■ THROTTLE WIRE
WARNING
After fitting up the wire, make sure that the throttle
cable is put in the throttle lever. if not, it is very
dangerous because the engine rotate after releasing
the throttle lever.
1. Hook the cable end into the hole of the throttle lever.
2. Wrap the band so as the throttle wire is fixed with the
(1) Fuel tank
F4
(2) Hanger
(3) Main pipe
(4) Bolt
■ ADJUSTING THE THROTTLE CABLE
1. After releasing the throttle lever, pull the throttle wire.
2. If the play is short or long, take off the air cleaner
(1) Handle bracket
F5
(2) Right handle
(3) Bolt
(4) Left handle
(5) Engine side
■ PROTECTOR
Wrap the waist pad around the shaft tube. (F6)
(1) Bolt
F6
(2) Clamp
(3) Main pipe
(4) Safety guard
And set the cable in the lever as shown in the picture.
(F4)
handle.
The normal play is 1 or 2mm when measured at the
carburetor side end.
cover, loosen the lock nut and adjust the play. (F5)
G
B
(1) Hole
(2) Throttle cable
(1) Adjust nut
(2) Lock nut
(1) Protector
9