Set Up - Zenoah BKZ315L Operator's Manual

6. Set up

WARNING
• Assemble each part correctly. Wrong assembly
might cause an accident.
• If you cannot do the assembling yourself, consult
the shop where you bought this product.
■ INSTALLING THE SHOULDER STRAP
1. Hook the upper part of the shoulder strap at the notch
on the top of the frame and pass it through the buckle
as shown in the Figure, then secure it firmly.
2. Put the hook at the lower part of the shoulder strap in
the strap installing location at the bottom of the frame.
(1) Buckle
(2) Frame
■ CONNECTING THE FLEXIBLE SHAFT
1. Remove the clamping bolt (M5xL9) in the center of
the end of the joint, and loosen the fastening bolt
(M5xL20) and the screw (M5xL18) for mounting the
throttle lever.
2. Insert the main pipe into the joint while turning it
clockwise and counterclockwise slightly.
3. Align the safety-lock hole of the joint with the hole of
the main pipe, screw the clamping bolt and fasten it
tightly.
4. Tighten the fastening clumping bolt (7) of the joint,
and fix the main pipe firmly.
[Tightening torque]
4.9 to 7.8 N m (0.5~0.8 kg
•
5. Screw the throttle-lever mounting screw, and fasten
it tightly.
(1) Screw (M5xL18)
(2) Clamping bolt (M5xL9)
(3) Safety-lock hole
(4) Main pipe
01-BKZ315L_GB_cs6＿二.indd 9
(3) Hook
(4) D-ring
m)
•
(5) Throttle lever
(6) Joint
(7) Clamping bolt
(M5xL20)
BKZ315L
G
B
GB-9
18/09/03 11:50