Set Up - Zenoah BK3420FL-EZ Owner's Manual

6. Set up

WARNING
• Assemble each part correctly. Wrong assembly
might cause an accident.
• If you cannot do the assembling yourself, consult
the shop where you bought this product.
■ ATTACHING THE SHOULDER STRAP
1. Pass the ring of the shoulder strap through the
hook(A) and fix it by the bolt securely.
2. Set the hook(B) of each shoulder strap to the D-rings
on the frame.
■ CONNECTING THE FLEXIBLE SHAFT
1. Remove the clamping bolt (M5xL10) in the center of
the end of the joint, and loosen the fastening bolt
(M5xL10) and the screw (M5xL18) for mounting the
throttle lever.
2. Insert the main pipe into the joint while turning it
clockwise and counterclockwise slightly.
3. Align the safety-lock hole of the joint with the hole of
the main pipe, screw the clamping bolt and fasten it
tightly.
4. Tighten the fastening bolt of the joint, and fix the main
pipe firmly.
[Tightening torque]
4.9 to 7.8 N m (0.5~0.8 kg
•
5. Screw the throttle-lever mounting screw, and fasten
it tightly.
(1) Screw (M5xL18)
(2) Clamping bolt (M5xL10)
(3) Safety-lock hole
(4) Main pipe
01-BK3420FL-EZ_GB_207＿三.indd 9
(A) UPPER SIDE
(B) LOWER SIDE
(1) Hook (A)
(2) Bolt
(3) D-ring
(4) Hook (B)
m)
•
(5) Throttle lever
(6) Joint
(7) Clamping bolt
(M5xL10)
6. Stretch the main pipe and the flexible shaft straight,
thrust the inner shaft into the main pipe while turning
it by hand, and connect the inner shaft to the shaft
of the main pipe. Unless the end of the inner shaft
appears from the flexible shaft, the inner shaft has
been correctly connected to the shaft of the main
pipe.
7. Turn the hole at the end of the flexible shaft upward,
align the square hole of the clutch dram with the
direction of the inner shaft, and thrust the flexible
shaft into the clutch housing until you hear a click.
IMPORTANT
After connecting the inner shaft to the shaft of the main
pipe, try to pull out the flexible shaft by hand to make
sure the flexible shaft does not come off.
BK3420FL-EZ
G
B
(1) Inner shaft
(1) Clutch housing
(2) Clutch dram
square-hole
(3) Hole
GB-9
12.9.21 1:24:14 PM