Weslo WLEX70907.0 User Manual page 6

3. Remove all parts from the Pivot Axle (3). Insert the
Pivot Axle into the Frame (1). Align the hole in the
center of the Pivot Axle with the hole in the center of
the Frame. Tighten an M5 x 10mm Machine
Screw (32) into the Frame and the Pivot Axle.
Slide the Left and Right Handlebars (40, 41) onto
the ends of the Pivot Axle (3). Slide an M8 Flat
Washer (38) onto each end of the Pivot Axle, and
then thread an M8 Nylon Locknut (9) onto each end
of the Pivot Axle. Tighten each Nylon Locknut until
at least two threads on the end of the Pivot Axle
extend past the Nylon Locknut. Make sure that the
Handlebars move freely.
Press a Pivot Endcap (50) onto each end of the
Pivot Axle (3).
Apply a small amount of liquid soap to the upper
end of each Handlebar (40, 41). Slide a Foam Grip
(42) onto each Handlebar. Make sure that there is
a Handlebar Endcap (55) in each Handlebar.
4. The Console (7) requires one "AAA" battery (not
included); an alkaline battery is recommended.
IMPORTANT: If the exercise cycle has been
exposed to cold temperatures, allow it to warm
to room temperature before inserting batteries
into the Console. If you do not do this, the con-
sole displays or other electronic components
may become damaged. See the inset drawing.
Remove the battery door from the back of the
Console and insert the battery into the Console.
Make sure that the battery is oriented as shown
by the diagram inside the battery compartment.
Then, reattach the battery door.
Next, plug the Reed Switch Wire (28) fully into the
socket on the back of the Console (7).
Slide the Console (7) onto the console plate. Note:
The Console is held by friction; it does not snap into
place.
3
42
55
41
3
38
9
50
4
6
42
40
38 9
32 Hole
1
7
Console
Plate
Battery
Battery Door
55
50
28