ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included
hex tools, assembly requires your own Phillips screwdriver
wrench
. A small amount of liquid soap is also required.
1. See the inset drawing. Remove the Shipping Insert
(54) from the Frame (1) and discard it.
Turn the Rear Stabilizer (2) so that the slot faces
downward, and insert the Rear Stabilizer into the
Frame (1). Attach the Rear Stabilizer with four M5 x
10mm Machine Screws (32).
2. Turn the Front Stabilizer (5) so that the square holes
face away from the saddle bracket on the front of
the Frame (1). Attach the Front Stabilizer with two
M8 x 40mm Carriage Bolts (18), two M8 Curved
Washers (14), and two M8 Nylon Locknuts (9).
and adjustable
1
1
54
2
2
9
5
5
32
1
Slot
14
1
Square
Holes
18