TP-Link TD-W8960N User Manual page 33

TD-W8960N
 Remove All: Click Remove All, then all the interface will be deleted in the table.
 Remove: Select the check box in the table above and then click Remove, the corresponding
interface will be deleted in the table.
4.4.2.2 ATM-EoA-IPoE
If your ISP provides an IPoE connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select EoA option for DSL Link Type
2. Click the Add button on the screen (as shown Figure 4-7). Select WAN Service Interface over
ATM PVC on the next screen (as shown Figure 4-8).
3. If your ISP provides an IPoE connection, select IPoE option for the WAN service type on the
screen (as shown Figure 4-9), and click Next button to continue.
4. Enter parameters in the following blanks to configure the WAN IP Address and click Next.
 Obtain an IP address automatically: Select this option, the Router will be able to obtain IP
network information dynamically from a DHCP server provided by your ISP.
300Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-14
Figure 4-15
25
(4.4.1.1 ATM interface).