Mount the unit by directing the pipe (1) down and backwards in the bracket (2). Secure the nut (3) towards the attachment BY HAND (tools can be needed when demounting). Attach the security clamp (4) behind the nut. The wind transducer connects to the Nexus Server.
Page 5
TWIN FIN Mounting step by step 1. Mark the mounting holes using 2. Drill the three mounting holes the bracket as an template using a 3,2mm drill 3. Mount the bracket with the three 4. Insert the transducer into the...
Page 6
Electric installation Connections to the NX2 Server If you already have a Nexus Network i.e. a Server, it is more practical to connect the transducer to the Server due to the single instrument cable installation. Note, set C71 in Wind Data instrument to OFF (see Wind Data Manual)
TWIN FIN Calibration In order to get correct readings on your instruments, the transducer has to be calibrated. There are three things that has to be done: Enter the calibration values from the supplied calibration certificate into the codes C56 to C62. (C55-C62 in Wind Data) Enter the misalignment of the transducer in calibration code C55.