Table of Contents
Advertisement
9. Question:
Why does the drill bit back up into the Chuck during the
sharpening procedure?
Answer:
Make sure the bit is tight in the Chuck before sharpening.
Your Chuck may be dirty. Follow the steps for cleaning the Chuck
on page 18.
10. Question:
When splitting, why don't I hear a grinding sound?
Answer:
The Chuck is not seated properly in the flat spots of the Splitting
Hole.
When inserting the Chuck into the Splitting Hole (with the
Splitting Hole facing you), align the flat spots and move the
Chuck either way until the flat spots mesh. Firmly and slowly
push the Chuck into the hole until the grinding sound stops.
11. Question:
Can I change a 135-degree drill bit into a 118-degree drill
bit?
Answer:
You can change the degree angle of any drill bit from 135 degrees
to 118 degrees.
The alignment and sharpening procedure will need to be
performed three or more times to remove the old angle and
produce the new angle desired.
17
www.DrillDoctor.com
Advertisement
Table of Contents
