Cleaning The Milk Frother Device Using The Clean Button; Preparing The Hot Water; Programming The Amount Of Water Automatically Delivered - DeLonghi EC850 Instructions For Use Manual

To prepare the Cappuccino: press button
To prepare the latte macchiato: press button
automatically prepares the coffee.
Please note!
button to heat the ducts of the milk frother device (see
successive paragraph).
subsequently the coffee. If wanting to interrupt the
delivery in progress, press the previously pressed button.
amount of milk or coffee inside the cup, keep the button
(within a few seconds) relative to the preparation in
progress pressed.
too long: the higher the milk temperature (5°C is ideal),
the poorer is the quality of the froth
Cleaning the milk frother device using the CLEAN
button
After every use of the milk functions, perform cleaning to
eliminate the milk residues as follows:
1. Leave the milk container inserted in the machine (it is not
necessary
2. Place a cup or other container under the frothed milk
spout tube.
and flash. When the lights stop flashing and the
appliance goes back to ready for use, release the "CLEAN"
button: the steam cleans the circuits inside the milk
frother.
Program the amount of coffee and milk in the cup for
cappuccino or milk
The machine has been set by default to deliver standard
amounts. If wanting to amend these quantities, proceed as
follows:
1. Place a cup under the spouts of the coffee spout and under
the milk spout tube.
2. Press the button relative to the preparation with milk to
be programmed and keep it pressed. After a few seconds,
the machine starts delivering the milk.
3. As soon as the wanted amount of milk in cup is reached,
release the button milk delivery stops.
Instructions for use
.
milk.
.
seconds.
The machine is now re-programmed according to the new
amounts of milk and coffee.

Preparing the hot water

Scalding hazard!
Do not leave the machine unattended when delivering hot
water. The spout heats up during delivery therefore, only the
black part must be held.
2. Place a cup under the spout (as near as possible to avoid
sprays).
3. Press the
and the appliance starts hot water delivery.
Please note!
button again.
Programming the amount of water automatically
delivered
If wanting to amend the set by default amount, proceed as
follows:
1. Place a cup under the spout.
2. Keep the
3. When the hot water in the cup reaches the required level,
lights flashing for three seconds.
The machine is now re-programmed according to the new
amount.
Cleaning
Attention!
clean the machine.
washer. No other part of the appliance can be washed in
the dishwasher.
or fouling as they might scratch the metal or plastic
surfaces.
11
button pressed.
en