Table of Contents
Advertisement
Lamp Alignment How-To
Often, after a new installation of a lamp, you will find that there is
an uneven field of light or what is referred to as a hot spot. This is
due to the most intense point of the lamp source not being
positioned optimally within the reflector.
There are three lamp alignment screws S2 provided at the base
of the projector head. Turning these screws allow you to optimize
the projection quality of the spot as well as the overall intensity of
the beam.
1. Project a white spot against any flat surface. Preferably the
surface should be white or pastel in color.
2. Turning the lamp alignment screws, try to position the hot
spot in the center of the beam as best as possible. This
could require many attempts on your part.
3. Once the hot spot is in the center of the spot, do your
best to turn all screws equally as to affect movement up or
down within the reflector.
4. As you move in and out of optimum lamp focus, you will see
the hot spot either gets wider or narrower. The goal is to
either totally diminish the hot spot by having it widen and
spread across the entire spot or moving the hot spot so that
it covers as much of the beam spot area as possible.
Power
Your product is equipped with switch-selectable AC power setting.
Warning!
Verify that the power select switch on your unit matches the line voltage applied. All
fixtures must be connected to circuits with a suitable Earth Ground.
•
To determine the power requirements for a particular fixture, see the label
affixed to the back plate of the fixture or refer to the fixture's specifications
chart.
•
A fixture's listed current rating is its average current draw under normal
conditions.
•
All fixtures must be powered directly off a switched circuit and cannot be run off a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is
used solely for a 0% to 100% switch.
•
Before applying power to a fixture, check that the source voltage matches the fixture's
requirement.
•
All fixtures must be connected to circuits with a suitable Earth Ground.
Intimidator™ 2.0 HTI User Manual
S2
Lamp Alignment Screws
Slide switch up or down
depending on your line voltage.
7
Setup
S2
2006-10-03/14:48
Advertisement
Table of Contents
