Supero SUPERSERVER 1027R-72RFTP User Manual page 69

GLAN/10G_LAN Enable/Disable
Use JPL1 to enable/disable LAN Ports 1/2,
and use JPL2 for TLAN Ports 1/2. See the
table on the right for jumper settings. The
default setting is Enabled.
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor that
can reboot the system when a software appli-
cation hangs. Close Pins 1-2 to reset the sys-
tem if an application hangs. Close Pins 2-3 to
generate a non-maskable interrupt signal for
the application that hangs. See the table on
the right for jumper settings. Watch Dog must
also be enabled in the BIOS.
BMC Enable/Disable
Jumper JPB1 allows you to enable the
embedded the Nuvoton BMC (Base-
board Management) Controller to pro-
vide IPMI 2.0/KVM support on the
motherboard. See the table on the right
for jumper settings.
SAS Enable/Disable
Use Jumper JPS1 to enable or
disable onboard SAS connections.
The default setting is on Pins 1/2 to
enable onboard SAS support. See
the table on the right for jumper
settings.
Chapter 5: Advanced Serverboard Setup
LAN1/2, TLAN1/2 Enable
Jumper Setting Defi nition
Pins 1-2
Pins 2-3
Jumper Setting
Pins 1-2
Pins 2-3
Open
Jumper Setting
Pins 1-2
Pins 2-3
SAS Enable
Jumper Settings
Jumper Setting
Pins 1/2
Pins 2/3
5-23
Jumper Settings
Enabled (default)
Disabled
Watch Dog
Jumper Settings
Defi nition
Reset (default)
NMI
Disabled
BMC Enable
Jumper Settings
Defi nition
BMC Enable (Default)
Normal
Defi nition
Enabled (Default)
Disabled