D.T. System Micro-iDT PLUS Series Owner's Manual page 9

Magnetic Switch Indicator (Red Mark)
The Red Mark indicates the location of the
Magnet Switch in the Collar Receiver and is
used to turn the Collar Receiver ON/OFF
and for ID Programming.
Collar Belt with MAXX-Range™ Antenna
The embedded Collar Antenna is woven into the
Collar Belt and runs the entire length of the belt. The
MAXX-Range™ Antenna gives the Collar Receiver
360˚ of clear signal reception.
If your Collar Belt is too long , we recommend looping the
excess Collar Belt back around through the buckle. We DO
NOT recommend cutting the Collar Belt. Cutting the Collar
Belt too much will drastically reduce the range of your Col-
lar Receiver. However, the Collar Belt can be cut up to
about 3 inches without affecting the range too much.
The Battery Charging Receptacle is located on the
side of the Collar Receiver. Always close the jack with
the rubber plug after charging to prevent foreign
particles from getting inside the Charging Receptacle.
The unit is still waterproof even if water gets into the Charg-
ing Receptacle. However, if water should get in, we recom-
mend rinsing out the Charging Receptacle and allowing it to
dry, especially after use in salt water. This will prevent pre-
mature corrosion in the metal pins inside that make contact
with the charger plug.
PARTS & FUNCTIONS
Battery Charging Receptacle
CAUTION
NOTE
9