Advertisement
QuickSpecs
Technical Specifications
SAS Quick Release LFF (3.5-inch) Midline (MDL) Drives
Application
Transfer rate
HP 4TB 6G SAS 7.2k rpm
LFF (3.5-inch) Quick-
release Dual Port MDL 1y
Warranty Hard Drive
HP 2TB 6G SAS 7.2K rpm
SAS Midline drives are intended for servers and storage solutions where high capacities are required.
These drives have moderately-priced reliability and performance for non-mission critical, low workload
applications, such as disk backup, archival, and reference applications.
The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server
backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated
down to an acceptable level for all components.
697956-B21
574761-B21
DA - 12244 North America — Version 44 — December 9, 2013
Operating Temperature
(System Inlet Air
Temperature)
Capacity
Height
Width
Depth
Interface
Transfer Rate
Synchronous (Maximum)
Seek Time
(typical reads, including
settling)
Physical Configuration
Operating Temperature
(System Inlet Air
Temperature)
NOTE: To support HP hard drives exceeding 2.2 TB, HP Smart Array Firmware
version 5.0 or later is required for the following controllers:
HP Smart Array P212 Controller
HP Smart Array P410 Controller
HP Smart Array P411 Controller
HP Smart Array P711m Controller
HP Smart Array P812 Controller
To use hard drives exceeding 2.2 TB, you must create a boot volume using
offline ACU version 8.75 or later. HP Smart Array controllers do not support
boot volumes exceeding 2.2 TB. Other controllers are not supported
Capacity
HP SAS Hard Drives
50° to 95° F (10° to 35° C)
4,000,787MB
1.165 in (29.6 mm)
4.157 in (105.6 mm)
5.787 in (147.0 mm)
SAS
6Gb/sec
Single Track
Average
Full-Stroke
Rotational Speed
Bytes/Sector
Logical Blocks
50° to 95° F (10° to 35° C)
2,000,398,934,016
0.7 ms
8.5 ms
15.7 ms
7,200 rpm
512
7,814,037,168
Page 32
Advertisement
