Advertisement
QuickSpecs
Technical Specifications
HP 3TB 6G SAS 7.2K rpm
LFF (3.5-inch) Midline 1yr
Warranty Hard Drive
HP 2TB 6G SAS 7.2K rpm
LFF (3.5-inch) Dual Port
Midline 1yr Warranty Hard
Drive
625031-B21
Capacity
Height
Width
Depth
Interface
Transfer Rate
Synchronous (Maximum)
Seek Time
(typical reads, including
settling)
Physical Configuration
Operating Temperature
(System Inlet Air
Temperature)
NOTE: To support HP hard drives exceeding 2.2 TB, HP Smart Array Firmware
version 5.0 or later is required for the following controllers:
To use hard drives exceeding 2.2 TB, you must create a boot volume using
offline ACU version 8.75 or later. HP Smart Array controllers do not support
boot volumes exceeding 2.2 TB. Other controllers are not supported
507616-B21
Capacity
Height
Width
Depth
Interface
Transfer Rate
Synchronous (Maximum)
Seek Time
(typical reads, including
settling)
Physical Configuration
DA - 12244 North America — Version 44 — December 9, 2013
3,000,592,982,016
1.04 in (26.4 mm)
4.36 in (110.7 mm)
7.43 in (188.7 mm)
SAS
6 Gb/sec
Single Track
Average
Full-Stroke
Rotational Speed
Bytes/Sector
Logical Blocks
50° to 95° F (10° to 35° C)
HP Smart Array P212 Controller
HP Smart Array P410 Controller
HP Smart Array P411 Controller
HP Smart Array P711m Controller
HP Smart Array P812 Controller
2,000,398,934,016
1.04 in (26.4 mm)
4.36 in (110.7 mm)
7.43 in (188.7 mm)
SAS
6 Gb/sec
Single Track
Average
Full-Stroke
Rotational Speed
Bytes/Sector
Logical Blocks
HP SAS Hard Drives
0.5 ms
<8.1 ms
15.5 ms
7,200 rpm
512
5,860,533,168
0.5 ms
8.5 ms
16.2 ms
7,200 rpm
512
3,907,029,168
Page 25
Advertisement
