Taclink - Hand Held Products NAUTIZ X7 Manual

Compass Settings
Setting Items Description
Set the reference altitude for the compass. You can either set a specifi c height (zero by
Altimeter
default) or use GPS positioning as the reference (GPS positioning will be initiated after you
tap OK).
Set to Needle for a pivoting needle on a fi xed dial or Wheel for a fi xed needle on a rotating
Rotation Type
dial.

TacLink

The TacLink program receives GPS satellite signals to calculate the location of your device. You can also record a NMEA log
fi le for the use of other applications.
NOTE: TacLink only supports NMEA format. TacLink will not start if you have set the GPS output
format to Binary Mode in
party programs.
Running TacLink
To run the program, tap
Shows the overhead satellite
positions.
Shows the signal strength
of the satellites.
A message appears if positioning is not completed in 10 minutes.
To exit the program, tap Exit at the bottom left of the screen.
Settings System
Programs TacLink.
NAUTIZ X7 Manual - Chapter 6
GPS Mode for the need of third
A red X indicates logging is not activated.
No X indicates logging is activated.
This icon appears only if SBAS is enabled.
(See the next section for information.)
Shows the result of GPS positioning. A
minimum of 4 GPS satellite signals is
needed to calculate your GPS position.
65