Alpine CVA-1004R Owner's Manual page 57

1 ISO Antenna Convertor Plug
2 Antenna Receptacle
3 Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a
cellular phone which provides ground shorting when a
call is received.
If a device having the interrupt feature is connected,
audio will be automatically muted whenever the
interrupt signal is received from the device.
4 Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
5 Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of the
parking brake switch to transmit the parking brake
status signals to the CVA-1004R.
6 Illumination Lead (Orange)
This lead may be connected to the vehicle's instrument
cluster illumination lead. This will allow the
backlighting of the CVA-1004R to dim whenever the
vehicle's lights are turned on.
7 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's
fuse box or another unused power source which
provides (+) 12V only when the ignition is turned on
or in the accessory position.
8 Ground Lead (Black)
Connect this lead to a good chassis ground on the
vehicle. Make sure the connection is made to bare
metal and is securely fastened using the sheet metal
screw provided.
9 Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power
antenna, if applicable.
NOTE
This lead should be used only for controlling the
vehicle's power antenna. Do not use this lead to turn on
an amplifier or a signal processor, etc.
! Battery Lead (Yellow)
Connect this lead to the positive (+) post of the
vehicle's battery.
Installation and Connections
" Fuse Holder (10A)
# ISO Power Supply Connector
$ Remote Control Interface Connector
% Remote Control Output Lead (White/Brown)
& RGB Input Connector
( Ai-NET Cable
) Power Supply Connector
~ Left Rear (+) Speaker Output Lead (Green)
+ Left Rear (–) Speaker Output Lead (Green/
, Left Front (+) Speaker Output Lead (White)
- Left Front (–) Speaker Output Lead (White/Black)
. Right Front (–) Speaker Output Lead (Grey/
/ Right Front (+) Speaker Output Lead (Grey)
: Right Rear (–) Speaker Output Lead (Violet/
; Right Rear (+) Speaker Output Lead (Violet)
< ISO Connector (Speaker Output)
= System Switch
To remote control interface box.
Connect this lead to the remote control input lead.
This lead outputs the controlling signals from the
remote control.
Black)
Black)
Black)
When connecting an equalizer or divider using Ai-
NET feature, place this switch in the EQ/DIV
position. When no device is connected, leave the
switch in the NORM position.
NOTE
Be sure turn the power off to the unit before changing the
switch position.
55
-EN