Installation - Alpine CDM-7870R Owner's Manual

Installation

Caution
When you install this unit in your car, do not remove
the Detachable Front Panel.
If the Detachable Front Panel is removed during
installation, you might press too hard and warp the
metal plate that holds it in place.
1
Bracket
Dashboard
Mounting sleeve
(Included)
Remove the Detachable Front Panel (refer to
page 5). Slide mounting sleeve from main unit
(see Removal Procedure below). Slide the
mounting sleeve into the dashboard.
2
Metal Mounting Strap
Hex Nut (M5)
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the CDM-7870R/
TDM-7585R and put the Rubber Cap on the hex
bolt. If your vehicle does not have the Mounting
Support, reinforce the head unit with the metal
mounting strap (not supplied). Connect all the
leads of the CDM-7870R/TDM-7585R according to
details described in the CONNECTIONS section.
NOTE
For the screw , provide a proper screw to the chassis
installing location.
Metal plate
Detachable
Front panel
Rubber Cap
(Included)
Hex Bolt
(Included)
CDM-7870R/TDM-7585R
Screw
Bolt Stud
CDM-7870R/TDM-7585R
3
Slide the CDM-7870R/TDM-7585R into the
dashboard. When the unit is in place, make sure the
locking pins are fully seated in the down position.
This can be done by pressing firmly in on the unit
while pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly
locked and will not accidentally come out from the
dashboard. Install the Detachable Front Panel.
Lock pin
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to
push the locking pins to the "up" position (see
above drawing). As each pin is unlocked, gently
pull out on the unit to make sure it does not re-
lock before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Front frame
CDM-7870R/
TDM-7585R
Screws (M5 8)
(Included)
Mounting Bracket
25
-EN