THOMSON SPEEDTOUCH 605S Setup And User Manual page 67

E-SIT-CTC-20030605-0003 v1.0
5 While holding the Defaults button, power on the SpeedTouch™ and keep holding
the Defaults button until the Power/System, Line Tx and Line Rx LEDs lit green
(approximately six seconds). This indicates that the SpeedTouch™ entered
BOOTP mode and is sending BOOTP requests.
6 The BOOTP server will reply to the BOOTP requests and will perform the
required operations to send the system software to the SpeedTouch™.
7 After checking whether the received system software is valid for the device, the
SpeedTouch™ will start in normal operational mode to complete the upgrade.
8 Optionally, you can upload the backup configuration as described in
page 47.
5 SpeedTouch™ System Software Upgrade
" System" on
63