THOMSON SPEEDTOUCH 605S Setup And User Manual page 64

5 SpeedTouch™ System Software Upgrade
60
5 The Setup wizard should find your SpeedTouch™ device on the local network.
This is indicated by the following window:
In case more than one SpeedTouch™ device is found, a listing is provided from
which you can select your SpeedTouch™ from.
Note If the Setup wizard does not find any SpeedTouch™ on the network an
error window pops up. In this case check:
• Whether the SpeedTouch™ is turned on and fully initialized.
•
Whether your computer is correctly connected to the Speed-
Touch™.
•
Whether no dedicated firewall device or router is placed
between your PC and the SpeedTouch™ and whether no
personal firewall software is running on your PC.
To repeat the search for the SpeedTouch™, click Back and proceed with step
this procedure.
6 Once the SpeedTouch™ Setup wizard has detected your SpeedTouch™ device
you can proceed with the upgrade procedure.
If more than one SpeedTouch™ device is listed, select the appropriate one.
Then, click Next to proceed.
7 The following window shows current the firmware version active on the Speed-
Touch™ as well as one or more firmware versions available on the CD-ROM.
Select the appropriate firmware version and click Next to continue.
Note If the Service Provider has included a separate disk with dedicated
upgrade system software, click Have Disk to navigate to the location of
the appropriate file.
In case of a system software downgrade you must specifically acknowledge your
decision before being able to proceed.
4 of
E-SIT-CTC-20030605-0003 v1.0