THOMSON SPEEDTOUCH 605S Setup And User Manual page 57

E-SIT-CTC-20030605-0003 v1.0
6 NAPT Manager will continue to search for the SpeedTouch™ on the network.
The following window shows the detection progress:
7 The NAPT manager should find your SpeedTouch™ device on the local network.
This is indicated by the following window:
In case more than one SpeedTouch™ device is found, a list with the different
devices is shown.Select the SpeedTouch™ of your choice and click Next.
Note If the Setup wizard does not find any SpeedTouch™ on the network an
error window pops up. In this case check that:
• the SpeedTouch™ is turned on and fully initialized.
•
your PC is correctly connected to the SpeedTouch™ and has a
valid IP address (i.e. any IP address but 0.0.0.0).
• no dedicated firewall device or router is placed between your PC
and the SpeedTouch™
•
no personal firewall software is running on your PC.
To repeat the search for the SpeedTouch™, click Back and proceed
with step 6 of this procedure.
4 SpeedTouch™ NAPT Manager
53