THOMSON SPEEDTOUCH 605S Setup And User Manual page 46

3 SpeedTouch™ Web Interface
NAPT
42
C
licking this button displays the Network Address and Port Translation (NAPT) page.
This page allows you to:
• View or add/delete specific static NAPT entries:
To add static NAPT entries proceed as follows:
1 Click New.
2 Specify the outside address and inside address for the entry as well as the
protocol and port to which the entry applies.
Note If the NAPT entry is applied to a connection's dynamically assigned
local peer IP address, you should specify 0.0.0.0 as the outside address.
3 Click Apply to add the entry to the table.
You can also add static NAPT entries semi-automatically using the SpeedTouch™
NAPT Manager. For more information on NAPT Manager, see
NAPT Manager" on page
•
View or add/delete Multi-NAT entries:
To add Multi-NAT entries proceed as follows:
1 Click New.
2 Specify the inside address and put the desired range between brackets e.g.
10.0.0.[1-10]. Specify the outside address and interface.
3 Click Apply.
51.
"4 SpeedTouch™
E-SIT-CTC-20030605-0003 v1.0