Quick Start - Parrot You Com User Manual

1

QUICK START

Step 1: Connect cables:
Connect the MIC/LINE cable to
the MIC/LINE-input and the
headphones cable to the
PHONES-connector on the rear.
Choose either the LINE or MIC
input with the LINE/MIC switch.
Select sensitivity with the H/M/L
switch (see below).
Step 2: Insert a memory card:
Insert a Secure Digital (SD) card
into the memory-slot on the left
hand side of the unit with the
card's topside facing away from
the belt-clip.
Switch ON the unit by pressing
for 1 second until the ON light
lights up. Green means there is
power in the battery.
The MEM light should not light up. This means that there is enough memory left
for a first recording.
Step 3: Adjust input level:
Press the level-controller on the
front briefly to light up [INPUT].
Talk into the microphone with a
level you think you will use.
Turn the level-control (while
[INPUT] is still lit) until your voice
makes the level-meter run into
yellow occasionally.
© 2005 Parrot 7