Input Sensitivity Switches - Parrot You Com User Manual

Press STOP on startup to enter the so-called hazard-mode (all lights blink for 2
seconds). Press REC during hazard-mode to erase the memory card. Press MARK
during hazard-mode to erase all user-set markers, unselect all clips and return to
only ' start of new recording' markers.
Press and hold GO on startup to enter the BlueTooth pairing-mode. The red NETW
light blinks until unit is paired or switched off (see also section 6.1).
3.2

Input sensitivity switches

The analog input can be selected to take in either a line level or a microphone level
signal. The selected input can furthermore be set to three levels of sensitivity.
Select line- or microphone-level
Use the LINE/MIC switch to select a
line level or a microphone level input
(see also Annex 4: Specifications)
Select low-, medium- or high-
sensitivity
Use the LINE/MIC switch to select
the right sensitivity. These switches
should be set in such a way that
while the level-control is set to about
70% (L7, see section 3.3):
the top red light of the level-indication-bar will not light up on a 'maximum
conceivable signal' (that would indicate an overload of the pre-amplifier).
there is still a few green lights showing on a signal with a 'normal' level and the
level-control set to about 6 red lights.
20 © 2007 Parrot