Record The Live Connection (Telephone Logging); Send Audio Files (Original High Quality) - Parrot You Com User Manual

6.3

Record the LIVE connection (telephone logging)

Press RECORD during a LIVE connection (see section 6.2) to record both the
outgoing and incoming signal as a 'stereo' file on the memory card. This way the
two signals are stored separately in two tracks and can for instance be edited later
on to change the individual levels.
6.4

Send audio files (original high quality)

The Parrot can either send the current take or a few selected clips (see section 5).
Make sure that CLIP is not blinking if you only want to send the current take or that
it IS blinking when you want to send only selected clips.
Sending a file can be done in one stage (using the modem function) or in 2 stages
(using the object push function):
Modem (1 stage): the selected file is sent directly into the studio's fileserver. All
required settings are pre-programmed in the user settings on the memory card. This
function can be selected by setting ' 0 -> Zmodem Modem Profile' and entering a
few parameters (see chapter 8).
Object Push (2 stage): The selected file is first sent to the memory of the mobile
phone and can then be sent by any means available (e.g. email through UMTS) to
different destinations. This function can be selected by setting '1 -> Object Push
Profile' (see chapter 8).
Press [GO] twice and the FILE
light on the front will turn on.
The NETW light will start blinking
fast to indicate that it is trying to
reach the paired Bluetooth device
(the mobile phone will ask if the
file can be stored in its' memory,
when the object push function is
used)
36 © 2007 Parrot