Table of Contents
Advertisement
Power Connection and Installation of the PCI Slot Bracket Fan Speed Controller
Figure 1-1
Figure 1-2
Figure 2
Figure 3-1
Figure 3-2
Figure 4
GH-PCU23-VE
Figure 1.
Remove the knob, bolt and controller from the 3.5" drive bay fan speed
controller panel in sequence
bolt and finally the knob to the PCI bracket
Figure 2.
Place the PCI bracket with the fan speed controller in the selected PCI
slot. Use screws to secure the PCI bracket in place.
Figure 3.
Connect one end of the provided power cable to the 3-pin header on
the cooler
. Connect the other end to the motherboard 3-pin
(Figure 3-1)
or 4-pin CPU fan header. Connect the small 3-pin power cable from
the controller to the small 3-pin header on the cooler
Figure 4.
Start your computer after the installation is complete. If there is an item
that allows for CPU fan speed control in system BIOS Setup, disable the
function. Use the fan speed controller to adjust the fan speed based on
your requirements.
- 14 -
. Secure the controller, then the
(Figure 1-1)
.
(Figure 1-2)
.
(Figure 3-2)
Advertisement
Table of Contents
