4-3 PCI Rear Fan Speed Controller Installation (as Figure a/b)
4-3-1
Place PCI rear fan speed controller to the back of the chassis (place on the lower
PCI is recommended as Figure c.)
Figure a
4-4 Tube Installation
After measuring the distance between each parts of the cooling system, cut the tubes into
five suitable sizes as it shows below. To get the right length for each tube, strongly recom-
mend to fit all the components in the right position.
Liquid Cooling System complete installation diagram.
Tube3: The inlet of radiator
to 4-way splitter
valve (1)
B
Tube1: 4-way splitter
valve (1) to the
outlet of the
waterblock
8
Figure b
A
B
Tube2 : 4-way splitter valve (2)
to the inlet of the
waterblock
Figure c
Tube4: The outlet of radiator
to the inlet of the
tank
A
Tube5 : 4-way splitter valve (2)
to the outlet of the tank