Supervisor / User Password - Gigabyte GA-586VX User Manual

SPP Using Parallel port as Normal Printer Port.
EPP Using Parallel port as Enhanced Parallel Port.
ECP Using Parallel port as Extended Capabilities Port.
ECP/EPP Using Parallel port as ECP & EPP mode/Enhanced
Parallel Port.
¯
As ECP,ECP/EPP Mode is selected, two options can be defined:
1. ECP Mode use DMA: 3
USB Controller
The default value is Disabled.
Enabled Enable USB Controller.
Disabled Disable USB Controller.

4.13. SUPERVISOR / USER PASSWORD

When you select this function, the following message will appear at the center
of the screen to assist you in creating a password.
ENTER PASSWORD
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP/PCI CONFIGURATION
LOAD BIOS DEFAULTS
LOAD SETUP DEFAULTS
ESC : Quit
F10 : Save & Exit Setup
Figure 4.10: Supervisor / User Password
Type the password, up to eight characters, and press <Enter>. The password
typed now will clear the previously entered password from CMOS memory.
You will be asked to confirm the password. Type the password again and
press <Enter>. You may also press <Esc> to abort the selection and not enter
¯
2. ECP Mode use DMA: 1
ROM PCI / ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
INTEGRATED PERIPHERALS
SUPERVISOR PASSWORD
USER PASSWORD
IDE HDD AUTO DETECTION
HDD LOW LEVEL FORMAT
Enter Password: SAVE & EXIT SETUP
EXIT WITHOUT SAVING
(Shift)F2
Change / Set / Disable Password
4-20
BIOS Configuration
¯
: Select Item
: Chang Color