Gigabyte GA-586VX User Manual page 79

Ö
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT
Cannot find or initialize the floppy drive controller. Make sure the controller
is installed correctly and firmly. If there are no floppy drives installed, be
sure the Diskette Drive selection in Setup is set to NONE.
Ö
Invalid EISA Configuration
PLEASE RUN EISA CONFIGURATION UTILITY
The non-volatile memory containing EISA configuration information was
programmed incorrectly or has become corrupted. Re-run EISA
configuration utility to correctly program the memory.
F
When this error appears, the system will boot in ISA mode, which allows
you to run the EISA Configuration Utility.
Ö
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure the keyboard is attached
correctly and no keys are being pressed during the boot.
If you are purposely configuring the system without a keyboard, set the
error halt condition in Setup to HALT ON ALL, BUT KEYBOARD. This will
cause the BIOS to ignore the missing keyboard and continue the boot.
Ö
Memory Address Error at ...
Indicates a memory address error at a specific location. You can use this
location along with the memory map for your system to find and replace
the bad memory chips.
Ö
Memory parity Error at ...
Indicates a memory parity error at a specific location. You can use this
location along with the memory map for your system to find and replace
the bad memory chips.
Ö
MEMORY SIZE HAS CHANGED SINCE LAST BOOT
Memory has been added or removed since the last boot. In EISA mode,
use Configuration Utility to re-configure the memory configuration. In ISA
mode, enter Setup and enter the new memory size in the memory fields.
Appendix A: Post Message
A-3