Table of Contents
Advertisement
TCP IP
TCP/IP Settings
Rendezvous Settings
AppleTalk
AppleTalk Settings
AXIS OfficeBasic USB Wireless G
Obtain TCP/IP settings automatically (use DHCP/BOOTP): If you click this
radio button, the print server will obtain IP settings automatically, provided
there is a DHCP/BOOTP server on your network.
Use the following TCP/IP settings: if you click this radio button, you will
disable DHCP in the print server and must enter the below parameters
manually:
•
IP Address: Enter the IP address of the print server. The IP address must
meet the IP addressing requirements of the network segment.
Subnet Mask: Enter the subnet mask of the print server. The subnet mask
•
must meet the IP addressing requirements of the network segment. Specify
the subnet mask used for determining when the traffic should be sent via a
router. This number combined with the IP address identifies on which
network the print server is located. The normal class C subnet mask value is
usually 255.255.255.0. The value: 0.0.0.0, indicates that all network
segments are accessible.
•
Default router: Enter the default router used by the print server. Specify
the IP address for the default router. All traffic directed outside the local
network, defined by the subnet mask, is sent to the default router. Any re-
routing via other routers is done automatically. The setting 0.0.0.0
indicates that no default router is set. If that is the case, the print server
anticipates that there is a router available that automatically senses and
redirects the print server's packets to destinations outside the local
network segment.
Rendezvous Settings: Enable or disable the Rendezvous protocol. Rendezvous
is enabled by default in the print server.
Service Name: Enter a Rendezvous Service Name for the print server. If nothing
is specified, the default service name is the print server name, i.e.
AXISxxxxxx Wireless Print Server, where xxxxxx represent the last six digits
of the print server's serial number.
AppleTalk: Select Enabled or Disabled.
Default = Enabled
Zone Name: Enter an AppleTalk Zone name that you want the print server to
belong to or leave it as the default value (the print server automatically
searches and links itself to the default zone that is set on the AppleTalk router,
if found). If no zone exists, the print server displays the zone name as an
asterisk (*).
Port Name: Enter a name for identification purposes or leave the default value
(recommended). The print server's default port name is AXxxxxxx_USB, where
xxxxxx represent the last six digits of the print server's serial number, found on
the label. The print server will append the last six digits to the name you
specify. Example: AX181cf0_USB
Print Server Management
25
Advertisement
Table of Contents
