Perform a Factory Default:
AXIS OfficeBasic USB Wireless G
1. Verify that the DIP switch is on "Nor."
2. Disconnect the external power supply.
3. Hold down the reset button.
4. Reconnect the external power supply. Wait for 5 seconds, and release the
button.
5. Release the reset button.
6. The print server will restart.
Important!
•
Performing a Factory Default will erase all settings of the print server to
default and should be performed with caution!
• After performing a Factory Default, the default wireless settings will be:
• Infrastructure mode
• SSID = <ANY> (will connect with the Access Point that has the best
signal in your wireless network)
• Data transmit rate = Auto
• Transmit mode = Auto
• Authentication Type = Open System
• Channel = 6
• DHCP enabled
Print Server Management
29