Download Print this page

KitchenAid KCC-151 Installation Instructions

Hide thumbs
   

Advertisement

Installation
Instructions
for your
new
undercounter
KCC-151 COMPACTOR
BEFORE YOU USE YOUR COMPACTOR
. . .
Be sure
your
compactor
IS properly
Installed
in an appropriate
level
area and a place
suitable
for the size,
functton
and protection
of the compactor.
ELECTRICAL REQUIREMENTS
Observe All Governing
Codes and Ordinances
A 120.Volt,
60 Hz. AC only. 15.Ampere
fused electrrcal
supply
IS required
(Time delay fuse or circuit
breaker
is
recommended
) It is recommended
that a separate
circuit
servrng
only thus appltance
be provided
DO NOT use
an extensron
cord.
RECOMMENDED
GROUNDING
METHOD
DO NOT,
UNDER
ANY CIRCUMSTANCES,
REMOVE
THE
POWER
SUPPLY
CORD
GROUND
PRONG.
For your
personal safety,
this
appliance
must be grounded
This
appliance
IS equrpped
with
a power
supply
cord
havtng
a 3-prong
grounding
plug
To mlnimlze
possble
shock
hazard,
the cord
must
be plugged
Into a matlng
3-
prong
grounding
type
wall
receptacle,
grounded
In
accordance
with
the
Natlonal
ElectrIcal
Code and local
codes
and
ordinances
If a mattng
wall
receptacle
IS not
avallable.
It IS the personal
responslbllity
and obligation
of
the customer
to have
a properly
grounded
3-prong
wall
receptacle
Installed
by a quaIlfled
electrIcIan.
See Figure
1
&PRONG
GROUNOING TYPE
WALL RECEPTACLE
POWER SUPPLY
FJGURE I
-lMPORlANT-
DO NOT REMOVE THIS INSTRUCTION SHEET UNTIL READY FOR INSTALLATION.
AFTER COMPLETING THE IMSTALIATION. SAVE THESE INSTRUCTIONS FOR FUTURE USE.

Advertisement

   Summary of Contents for KitchenAid KCC-151

  • Page 1

    Installation Instructions for your undercounter KCC-151 COMPACTOR BEFORE YOU USE YOUR COMPACTOR . . . Be sure your compactor IS properly Installed in an appropriate level area and a place suitable for the size, functton and protection of the compactor.

  • Page 2

    INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY CAREFULLY. THEY WILL SIMPLIFY THE INSTALLATION. the umt on either of Its sides on the corner posts. After removing the shipping carton, be sure to remove corner posts will protect the finish of the compactor all protective...

  • Page 3

    Loosen screws In the retaining brackets. Rotate brackets from shipping posrtion to the install position. Retighten. See Figure /qziJYqr FIGURE 15 FIGURE 12 NOTE: Position “A’‘-Compactor frame willbe flush with Replace the drawer. cabinets. Remove cabinet mount screws from retaining brackets.

  • Page 4

    Replace the handle with the screws removed In Step 2 one of the panels above. Replace the drawer 22-15/16’ -M-5/6’; FIGURE 18 KITCHENAID DIVISION TROY, OHIO 45374 Part No. 780521 FORM 14736 (12-83)

Comments to this Manuals

Symbols: 0
Latest comments: