electrolux
32
what to do if...
What to do if...
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that it is possible that the red pilot light of the
7
button
blinks, one of the following messages appears on the display and the
buzzer sounds a jingle to indicate that the appliance is not working:
problem with the water supply:
●
«Cannot fill water. Please chekc that the tap is open and then press
problem with water draining:
●
«Cannot drain the water. Please check that the filter is clean and then press
door open:
●
«Please check that the door is closed properly and then press
Once the problem has been eliminated, press the button
after all checks, the problem persists, contact your local Service Centre.
Malfunction
The washing machine
does not start:
The machine fills then
empties immediately:
On the diplay appears the
message: "Anti-flooding
system has been
activated. Please check
inlet/drain pipe
connections."
Possible cause
The door has not been
●
closed.
(Please check that
the door is closed properly
and then press
The plug is not properly
●
inserted in the power
socket.
There is no power at the
●
socket.
The main fuse or the fuse in
●
the plug has blown.
The selector dial is not
●
correctly positioned and the
7
button
has not been
depressed.
The delay start has been
●
selected.
The child safety lock has
●
been activated.
The end of the drain hose is
●
too low.
There is a water leakage
●
from the connections
7
to restart the programme. If
Close firmly the door.
●
.
)
Insert the plug into the
●
power socket.
Please check your domestic
●
electrical installation.
Replace the fuse.
●
Please turn the selector dial
●
and press the button
again.
If the laundry are to be
●
washed immediately, cancel
the delay start.
Deactivate the child safety
●
lock.
Refer to relevant paragraph
●
in "water drainage" section.
Close the water tap, unplug
●
the machine and call the
Customer Service Centre.
»
»
».
Solution
7