Electrolux EWN 14991 K User Manual page 14

electrolux use
14
spin phases and increases the number
of rinses in some programmes.
Rinse Hold : by selecting this
option the water of the last rinse is not
emptied out to prevent the fabrics from
creasing. When the programme has
finished the display shows the icon of
the selected programme and the
message «Finished», while on the
2.5
display ( and
and the current time appear. The
buzzer sounds a short jingle (if it's
activated), the pilot light of the button
is off and the door is locked to indicate
that the water must be emptied out.
To empty out the water, please
read the paragraph «At the end of
the programme».
Night Cycle
option, the machine will not drain the
water of the last rinse, so as not to
wrinkle the laundry.
As all spinning phases are suppressed,
this washing cycle is very noiseless and
it can be performed at night or in times
with a more economical power rate. In
some programmes the rinses will be
performed with more water.
When the programme has finished the
display shows the icon of the selected
programme, below the icon of the
selected programme and the message
«Finished», while on display (
2.6
) the end cycle and the current time
appear. The pilot light of the button
is off and the door is locked to indicate
that the water must be emptied out.
To empty out the water, please
read the paragraph «At the end of
the programme».
2.6
) the end cycle
: by selecting this
2.5
and
Select the options
Depending on the selected programme
only certain options are available and
shown during the selection phase on
the display (
Note: Not all the options are
compatible among themselves. The
uncompatible option icons will
disappear.
Important!
For the compatibility among the
washing prgrammes and options, refer
7
to «Washing programmes».
To select the desired options, first turn
the selector dial (
programme and don't press the
7
button .
Press the buttons
the options menu. Using Up
Down
through all the available options.
The display will show, using all the
visible area, the selected option in
highlighted mode. The corresponding
icon will appear on the right side of the
display and just below it, a short
message describes the status of the
option («Off» or «On»). See the below
example:
7
Press the button
confirm your choice, press it again to
deactivate the selected option.
2.3 2.4
and ).
1
) to desired
5
, you can activate
button you can move
6
to activate and
or