Table of Contents
Advertisement
22 electrolux
INSTALLATION
UNPACKING
All transit bolts and packing must be re-
moved before using the appliance.
You are advised to keep all transit devices
so that they can be refitted if the machine
ever has to be transported again.
1. After removing all the packaging, care-
fully lay machine on it's back to remove
the polystyrene base from the bottom.
2. Remove the power supply cable and
the draining and inlet hose from the
hose holders on the rear of the appli-
ance.
3. Unscrew the three bolts.
4. Slide out the relevant plastic spacers.
5. Open the porthole, take out the inlet
6. Fill the smaller upper hole and the two
POSITIONING
2
Install the machine on a flat hard floor.
1
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or other kitchen units. Level
the washing machine by raising or lowering
the feet. The feet may be tight to adjust as
they incorporate a self locking nut, but the
machine MUST be level and stable. If nec-
hoses from the drum and remove the
polystyrene block fitted on the door
seal.
large ones with the corresponding plas-
tic plug caps supplied in the bag con-
taining the instruction booklet.
Advertisement
Table of Contents
