Table of Contents
Advertisement
DISPLAY
5.1:
• Duration of selected programme
After selecting a programme, the duration
is displayed in hours and minutes (for ex-
ample
). The duration is calculated
automatically on the basis of the maxi-
mum recommended load for each type of
fabric. After the programme has started,
the time remaining is updated every mi-
nute.
• Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for exam-
ple
(see chapter «What to do if...»).
• End of programme
When the programme has finished three
blinking zeros (
Door pilot light (8.2), the Washing pilot
light (8.1) and the pilot light of button 6
go out and the door can be opened.
• Incorrect option selection
If an option which is not compatible with
the set wash programme is selected, the
message Err is displayed for a few sec-
onds and the red pilot light of button 6
light starts blinking.
• Delay Start
The selected delay set by means of the
relevant button appears on the display for
PERSONALISATION
ACOUSTIC SIGNALS
The machine is provided with an acoustic
device, which sounds in the following ca-
ses:
) are displayed, the
a few seconds. The delay time value de-
creases by one unit every hour. When
only 1 hour remains, the time decreases
every minute.
5.2:
• Heating Phase
During the washing cycle the display
shows a temperature icon (5.2) to indi-
cate that the appliance has started the
heating phase of the water in the tub.
5.3:
• Child safety lock
This device permits you to leave the ap-
pliance unsupervised without having the
worry that children might be injured by or
cause damage to the appliance. This
function remains able also when the
washing machine is not working.
There are two different ways to set this
option:
– before pressing button 6: it will be im-
possible to start the machine;
– after having pressed the button 6: it will
be impossible to change any other
programme or option.
To enable (disable) this option press si-
multaneously for about 6 seconds 3 and
4 buttons until the symbol 5.3 appears
(disappears) on the display.
• at the end of the cycle
• if there is a fault.
By pressing the 2 and 3 buttons simultane-
ously for about 6 seconds, the acoustic
signal is deactivated (except if there is a
electrolux 7
Advertisement
Table of Contents
