Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Electrolux EWH 127310 W
Summary of Contents for Electrolux EWH 127310 W
- Page 1 user manual Washing Machine EWH 127310 W...
-
Page 2: Table Of Contents
2 electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Care and cleaning Product description What to do if… Control panel Technical data Personalization Consumption values First use Installation Daily use Electrical connection Helpful hints and tips... - Page 3 3 • When unpacking the appliance, check • Never pull the power supply cable to re- that it is not damaged. If in doubt, do not move the plug from the socket; always use it and contact the Service Centre.
-
Page 4: Product Description
4 electrolux To disable this device and restore the pos- ton counterclockwise until the groove is sibility of closing the door, rotate the but- vertical. PRODUCT DESCRIPTION This appliance is provided with two inlet hoses: one for the cold water and one for the hot water supplied whether by alternative heating sources (solar panel, waste thermal treatment,…) or by traditional sources (gas-fired boiler, Diesel oil boiler,…). -
Page 5: Control Panel
5 Detergent dispenser drawer Compartment for detergent used for pre- wash and soak phase or for stain remover used during the stain action phase (if availa- ble). The prewash and soak detergent is added at the beginning of the wash pro- gramme. - Page 6 6 electrolux Display Delay Start button Start/Pause button Indicator pilot lights Programme Selector dial: table of symbols = Cotton = Wool = Hot Water Connection (Aqua- = Soak Sol) = Cold wash = Rinse = Synthetics = Drain = Delicates...
- Page 7 7 Hot Water Connection Indicator pilot lights This appliance is provided with two inlet ho- ses: one for the cold water and one for the hot water. The programmes of the selector dial indicated by the symbol automatically load hot water as well as cold water. If you...
-
Page 8: Personalization
8 electrolux ly 1 hour remains, the time decreases ev- ample ). The duration is calculated ery minute. automatically on the basis of the maxi- 5.2: mum recommended load for each type of • Heating Phase fabric. After the programme has started,... - Page 9 9 Measure out the detergent and the fab- ric softener Select the required programme by Pull out the dispenser drawer until it stops. turning the programme selector dial (1) Measure out the amount of detergent re- You can choose the right programme for...
- Page 10 10 electrolux Reduce the spin speed by pressing You must select this option after you have set the programme and before you press button 2 button 6 . When the required programme has been se- You can cancel or modify the delay time at lected, your appliance automatically propo- any moment, before you press button 6 .
-
Page 11: Helpful Hints And Tips
11 Before you make any change, you must attention to the water level and temper- PAUSE the appliance by pressing the but- ature!) . ton 6 . After closing the door, it is necessary to se- Changing a running programme is possible lect the programme and options again and only by resetting it. - Page 12 12 electrolux Button up pillowcases, close zip fasteners, Detergents and additives hooks and poppers. Tie any belts or long Good washing results also depend on the tapes. choice of detergent and use of the correct Remove persistent stains before washing.
-
Page 13: Washing Programmes
13 ter hardness degree is medium or high we When the degree of hardness is soft, read- suggest you to add a water softener follow- just the quantity of the detergent. ing always the manufacturer’s instructions. WASHING PROGRAMMES Programme... - Page 14 14 electrolux Programme Maximum and Minimum Temperature Cycle Description Detergent Options Maximum Spin Speed Compartment Maximum Fabrics Load Type of Laundry SPIN REDUCTION HANDWASH NIGHT CYCLE RINSE HOLD WOOL 40° - 30° - Cold Main wash - Rinses Maximum spin speed 900 rpm Max.
-
Page 15: Care And Cleaning
15 Programme Maximum and Minimum Temperature Cycle Description Detergent Options Maximum Spin Speed Compartment Maximum Fabrics Load Type of Laundry DRAIN Draining of water Max. load 7 kg For emptying out the water of the last rinse in pro- grammes with the Night Cycle or Rinse Hold option se- lected and at the and of the Soak programme. - Page 16 16 electrolux according to the softening powder manufac- turer's instructions. This will help to prevent the formation of lime deposits. After each wash Leave the door open for a while. This helps to prevent mould and stagnant smells form- ing inside the appliance. Keeping the door open after a wash will also help to preserve the door seal.
- Page 17 17 Drain pump The pump should be inspected regularly and particularly if: • the appliance does not empty and/or spin; • the appliance makes an unusual noise dur- ing draining due to objects such as safety pins, coins etc. blocking the pump.
- Page 18 18 electrolux 9. Put the cap back on the emergency emptying hose and place the latter 6. When no more water comes out, un- back in its seat. screw the pump cover by turning it anti- 10. Replace the filter into the pump by in- clockwise and remove the filter.
- Page 19 19 When the appliance is in use and depend- ing on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When...
-
Page 20: What To Do If
20 electrolux 3. screw the water inlet hoses back on and Important! Every time you drain the water reposition the emergency emptying through the emergency emptying hose you hose after having refit the cap on. must pour 2 litres of water into the main... - Page 21 21 Problem Possible cause/Solution The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. • Clean the drain filter. The machine does not emp- An option or a programme that ends with the water still in the tub ty and/or does not spin: or a that eliminates all the spinning phases has been selected.
-
Page 22: Technical Data
22 electrolux Problem Possible cause/Solution The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redis- tributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can re- sume. -
Page 23: Consumption Values
23 CONSUMPTION VALUES Only cold water loading Programme Energy consumption Water consumption Programme duration (KWh) (litres) (Minutes) White Cottons 90° Cottons 60° 1.05 Cotton ECO 60° For the duration of the programmes, Cottons 40° 0.77 please refer to the Synthetics 60°... - Page 24 24 electrolux 5. Open the porthole, take out the inlet ho- ses from the drum and remove the poly- styrene block fitted on the door seal. 3. Unscrew the three bolts. 4. Slide out the relevant plastic spacers. 6. Fill the smaller upper hole and the two...
- Page 25 25 Positioning Water inlet Install the machine on a flat hard floor. The inlet hoses are supplied with the appli- Make sure that air circulation around the ma- ance and can be found inside the machine chine is not impeded by carpets, rugs etc.
- Page 26 26 electrolux 2. Set the hoses correctly by loosening the • Hooked over the edge of a sink using ring nut. After positioning the inlet ho- the plastic hose guide supplied with the ses, be sure to tighten the ring nut again machine.
-
Page 27: Electrical Connection
27 ELECTRICAL CONNECTION Information on the electrical connection is injury through failure to comply given on the rating plate on the inner edge with the above safety precaution. of the appliance door. The power supply cable must be Check that your domestic electrical installa-... - Page 28 192991121-00-242010...