Table of Contents
Advertisement
ENGLISH
Settings
NOTE
MODE
CONTROL
Operation mode select switch
The
,
,
switch
must be set before turning the power on. Settings which are
changed after powering on will not be registered. In such cases, the
power should be switched off and on again.
[Rear panel]
Operation mode
MODE
select switch
SPEAKERS
SPEAKERS
SPEAKERS
Input select
switch
6
Change the input mode
Change the input mode for each channel (L1 ~ L5, R1 ~ R5).
Input select
and
Input select switch
Set the
XLR
•
: Use XLR terminal.
RCA
•
: Use RCA terminal.
OFF
•
: Channel is not used.
NOTE
• When the input and
SPEAKERS
SPEAKERS
different, the unit does not operate.
CONTROL
• If
is set to "AVP", this setting is invalid.
Change the operation mode
Change the operation mode for each channel (L1 ~ L5, R1 ~ R5)
or pair channel (L1 / L2, L3 / L4, L5 / R5, R1 / R2, R3 / R4).
Bi-AMP / NORMAL / BRIDGE mode selection
Set how to use the power amp with each channel.
Operation mode select switch
Set the
Bi-AMP
•
: Used for Bi-Amp connection.
CONTROL
NORMAL
•
: Used for NORMAL connection.
BRIDGE
•
: Used for BRIDGE connection.
NOTE
• Channels that have the input mode set to "OFF" can not be
selected.
CONTROL
• If
is set to "AVP", this setting is invalid.
.
Input select switch
setting on the unit are
.
Change the control mode
Select the option suited for the equipment operating the unit.
CONTROL
Select
.
AVP
•
: Operates the unit from the AVP-A1HD (vpage
7).
OFF
•
: Control mode is not used.
EXTERNAL
•
: Operates the unit from equipment connected
to the RS-232C connector or TRIGGER IN jack
(vpage 12).
CONTROL
When
is set to " AVP", the PRE AMP CONTROL LINK indi-
cator lights in blue.
OPTION / 1 / 2 mode selection
Use control link to connect POA-A1HD and AVP-A1HD and switch
POA-A1HD according to the number of units to be connected.
MODE
Select
.
OPTION
•
: For future use, if the range of functions is expanded.
1
•
: Used as the fi rst unit when one POA-A1HD unit is
used or two POA-A1HD units are connected.
2
•
: Used as the second unit when two POA-A1HD units
are connected.
Advertisement
Table of Contents
